SSAS Tabular – Smart ProcessAdd

Add Data to SSAS Tabular Hourly

In order to add some data into SSAS Tabular model, you can basically follow two options to achieve this:

  • Use Partitions
  • Use Process ADD

Considering SSAS Tabular, using partitions is sometimes a little bit controversial. Therefore, you should be aware of the possible impact and you should be also prepared for proper testing of such an approach. On the other hand, ProcessAdd is much convenient option which you might prefer.

Smart ProcessAdd

There are many ways to implement ProcessAdd, as described by Marco or Cathy Dumas here and here. Your preference mainly depends on your knowledge and particular needs. I decided to keep SSAS layer and XMLA processing command simple. Therefore, I put “intelligent” part into SQL layer and SSIS Package.

Solution Components:

  • SSAS tabular table with one partition, which is loading data through stored procedure (not SQL Select – nor View- but SQL Stored Procedure) – let’s call it usp GetSSASData
  • SQL layer
    • Information on data rows when it was loaded into DW.
    • Help table with information what was loaded to SSAS already
      • Stored Procedures operating help table. (setting meta information)
    • Stored Procedure getting only new data into SSAS (usp GetSSASData)
  • SSIS Package orchestrating incremental (as well as full) processing

Solution might be clear while checking the following figure (basic steps shown below) for ProcessAdd workflow in SSIS package. (As mentioned in my last blog, it is necessary to check whether there is something to be loaded.)

Figure 1 – SSIS Package Workflow

Main advantages:

  • Simple XMLA Command (You can call simply ProcessAdd against particular partition with no worries about underlying SQL command structure)
  • No scripting or implementing with code acting with SSAS object model.
  • No change of SSAS structure.

The biggest down side of the solution:

  • The solution is based on metadata – therefore wrong data would be loaded into SSAS as you do processing manually aside of prepared process.

Conclusion

As for the conclusion, implementing an incremental load of the data into SSAS Tabular model via “smart” SQL Stored procedure simplifies ProcessAdd command maintenance and implementation. Moreover, it’s not necessary to implement additional logic in different tool such as PowerShell.

Previous Post
SSAS Tabular – When ProcessAdd Fails
Next Post
Crime analysis for Czech Republic in Power BI

Related Posts

No results found.

4 Comments. Leave new

  • Hi Roman,
    I’m trying to setup a similar approach as described in your article, namely having a helper table which will tell SSAS what to process. For some reason, I can’t see “Figure 1 – SSIS Package Workflow” on this page – is it missing or something with my browser perhaps?
    Cheers,
    Jean

    Reply
  • Hi,

    I’ve used an option ProcessAdd for auto incremental load, but every time i process the partition the data gets doubled/duplicated.

    Can you please help me with reason and solution.

    Before processing the partition, I’ve selected ProcessAdd option on partition and configure the query as:
    Select * from TableName.

    Thanks

    Reply

Leave a Reply to Roman Lánský Cancel reply

Your email address will not be published. Required fields are marked *

Fill out this field
Fill out this field
Please enter a valid email address.
You need to agree with the terms to proceed

Menu